Quick Start - Dser RoboGeek 21T User Manual

Quick Start

1.
Plug in the Charging Dock and place
the remaining wire into the trunking
at the bottom of the Charging Dock
Failure to place the remaining wire into the
trunking, may cause Robot to become stuck
while charging or cleaning.
2. Place the Charging Dock on a hard
level surface and against a wall.
3.
Charging Dock Position
Place the Charging Dock against the wall and make sure
it is in an open and uncluttered area leaving at least:
2 meters (6 feet) in front of the Charging Dock.
1 meters (3 feet) on both sides of the Charging Dock.
4.
Install Side Brushes
Attach Side Brushes to the bottom of Robot by pressing a brush
into each slot until it clicks.
5.
Activate the Robot
Place Robot onto the Charging Dock, making sure the metal
charging contacts on the Charging Dock match up with those
underneath the robot.
Initial Use, Switch on the Power Button on the Bottom.
If successful, you will hear a series of tones. Once the
Power button illuminates, Robot is ready for use.
10