Advertisement
(6) Loosen the screw shown in the illustration.
(7) Move the punch unit back and forth to adjust its
position, referring to the guide lines.
Guide lines
(8) After the adjustment, tighten the screw loosened
in step (6).
(9) Reattach the covers and other parts removed in
steps (4) and (5) by reversing the removal proce-
dure.
(10) Slide the Finisher into the main unit.
(11) Make a copy and check the punch hole posi-
tions again.
<Punch regist loop size adjustment>
(1) Make a copy in the punch mode.
(Refer to the User's Guide CD)
(2) Check the tilt of the output paper.
Note:
If it tilts, follow the procedures below for punch
loop adjustment.
(3) Display the Service Mode screen.
(For details of how to display the Service Mode
screen, see the service manual.)
(4) Touch "Finisher."
(5) Touch "FS-FN adjustment."
(6) Touch "Punch Regist Loop Size."
(7) Set the correction value using the
keys.
• To make loop length larger, enter a positive
value.
• To make loop length smaller, enter a negative
value.
(8) Touch "END."
(9) Touch "OK."
(10) Touch "Exit" on the Service Mode screen.
(11) Make a copy again and check the deviance of
punch hole position.
E-8
/
Advertisement
