Advertisement
3. Configuration procedures
<Punch option setting>
(1) Plug the power cord into the power outlet and
turn ON the power switch.
(2) Display the Service Mode screen. (For details of
how to display the Service Mode screen, see the
service manual.)
(3) Touch "Finisher."
(4) Touch "Punch option setting."
(5) Touch "PK-519" and select a desired number of
holes.
(6) Touch "decision."
(7) Touch "END."
(8) Touch "Exit" on the Service Mode screen.
(9) Turn OFF and ON the power switch.
Note:
When displayed the Service Mode screen, be sure
to turn off the main power after exiting the Service
Mode screen and wait for 10 seconds or more
before turning on.
4. Adjustment procedures
<Punch hole deviance adjustment>
(1) Make a copy in the punch mode.
(Refer to the User's Guide CD)
(2) Fold the copy into halves and check for possible
deviation in the punch hole positions.
Specifications: 0 ± 2.0 mm
Note:
If the positional deviation of the punch holes is not
within the accepted range, take the following
steps.
(3) Slide the finisher by pulling its lever.
(4) Remove the C-clip and remove the lever shown
in the illustration from the punch unit.
Lever
(5) Remove the cover shown in the illustration from
the punch unit. (One screw)
E-7
C-clip
Advertisement
