Advertisement
(6) Attach the supplied stopper pin to the paper feed
side of the finisher at the position shown in the
illustration. (One supplied screw A)
(7) Remove the cover shown in the illustration from
the finisher. (Three screws)
(8) Remove the knockout from the cover removed in
step (7) with nippers.
(9) Remove the screw shown in the illustration from
the finisher.
(10) While being careful with harness routing, slide
the plate shown in the illustration in the " PK"
direction. Insert the tab located at the end of the
plate into the rectangular hole on the frame.
(11) Secure the plate with the screw removed in
step (9).
Tab
E-3
Advertisement
