Advertisement
(22) Slide the finisher out by pulling its lever.
(23) Attach the supplied rail cover to the finisher.
a) Set the rail cover at the end of the rail.
Note:
Make the finisher's harness come out from the rail
cover at the position shown in the illustration.
b) Horizontally slide the rail cover.
Note:
• Make sure the cover's protruding part doesn't
lay over the tube.
• Secure the tabs, on the finisher's side, below
the rail cover.
Tube
< OK >
Protruding part
< NG >
E-6
c) Secure the rail cover with the screw (front side)
and the shoulder screw (rear side).
Note:
Use the shoulder screw and the screw supplied
with the finisher.
(24) Slide the finisher into the main unit.
(25) Affixing the label.
Note:
Perform the following steps only when necessary.
a) Slide the finisher by pulling its lever.
b) By turning the lever of the punch unit, rotate the
punch unit. Affix the label supplied with the Fin-
isher FS-533 to the main unit at the position
shown in the illustration.
c) Return the punch unit, slide the finisher into the
main unit.
Advertisement
