Advertisement
(12) Remove the lock part from the back of the fin-
isher, then install by sliding in the " PK" direc-
tion. (One screw)
(13) By pulling the finisher's lever, extend the front
rail to the maximum.
(14) Remove the lock part from the front rail, then
install by sliding in the " PK" direction. (One
screw)
(15) Fit the two tabs on the finisher into the rectan-
gular holes on the punch unit.
(16) Secure the punch unit with the supplied screw
B.
(17) Connect the two connectors of the punch unit to
the board of the finisher.
(18) Align the slit of the stopper arm with the pin on
the stopper pin so that the punch unit is
secured to the finisher.
E-4
Advertisement
