Advertisement
2
7
8
1
3
1
b
Tightening torque 4.0 N·m (0.40 kgf·m, 3.0 lb·ft)
INSTALLING THE INCLUDED PARTS
3
2
9
a
– 10 –
Check that the front brake hose 1, rear brake
hose 2, rear shift wire 3, joint sleeve 7 and
plastic locking ties 8 are placed as shown in
the illustration.
Check that the rear brake hose 2, rear shift
wire 3 and speed sensor lead 9 are routed as
shown in the illustration.
10. Tightening the seat pin
Insert the saddle and seat post 1, then tighten
the bolts a to the specified torque.
1
Saddle and seat post
WARNING
8 Insert the seat post far enough that the raise
limit b is not visible. If installed at a posi-
tion at which the raise limit b is visible, the
seat post, clamp, or even frame may break,
which could cause the rider to lose control
and fall.
8 Always tighten fasteners to the correct
torque. Bolts that are too tight can stretch
and deform. Bolts that are too loose can
move and fatigue. Either mistake can lead
to a sudden failure of the bolt, causing the
rider to lose control and fall.
1
A
Advertisement
