Subscribe to Our Youtube Channel
Related Manuals for Schweigen EV-6UCQ
Summary of Contents for Schweigen EV-6UCQ
- Page 1 RANGEHOOD & INSTALLATION GUIDE EV-6UCQ EV-9UCQ www.schweigen.com.au Revision V2_161219...
- Page 2 Index Before Installation Important Information Maintenance & Service Led Bulb Replacement Electrical Cord For Users Description Rangehood Contents Operation Cutout Size 4. Installation Rangehood Size Vs Cooktop Size Overhead Cabinet Rangehood Installation Position Recommended Installation Height For Induction Cooktop Mounting Points Overview Condensation Information Troubleshooting...
- Page 3 1. Before Installation Important • Please read this section thoroughly before attempting to install or operate the rangehood. Inspect your product upon receipt. Any damage or defects MUST be reported within 48 hours, or no claim will be recognised. • Before installing the electrical connections, you should: –...
-
Page 4: Maintenance And Service
2. Maintenance & Service • CAUTION: Accessible parts may become hot when used with cooking appliances. • We recommend this appliance be installed and repaired by a qualified technician. • It is dangerous to modify any part of this appliance. Modification of any kind, will immediately void the warranty. -
Page 5: Led Bulb Replacement
2. Maintenance & Service LED Bulb Replacement • Switch off the power to the canopy hood and allow the bulb to cool. • Remove the bulb by turning it by hand in an anti clockwise direction • Care must be taken to avoid the bulb falling onto the hob top •... -
Page 6: Rangehood Contents
3. Description Rangehood Contents 1. Power to external motor system 2. Male Plug (Main Power 240V) 3. Single 200mm Outlet 4. Reducer – only for Hiflow & Isodrive 650 motors 5. Filter 6. Light Note: Filter and light quantity may vary from model to model. - Page 7 4. Installation Rangehood Size vs Cooktop Size In addition to the size, the height of the rangehood above the cooktop is important to obtain the best performance. INADEQUATE ADEQUATE OPTIMAL Rangehood smaller than Rangehood same size as Rangehood larger than cooking zone cooking zone cooking zone...
-
Page 8: Mounting Instructions
Recommended Installation Height for Induction Cooktop To help avoid condensation, particular to cooking with an induction cooktop, Schweigen recommends a height of 700mm. Refer to page xx for further information. * Important: Please check all State and Federal Laws in relation to the minimum–maximum heights,... -
Page 9: Side View
4. Installation SIDE SIDE VIEW SIDE VIEW SIDE VIEW MOUNTING POINTS The diagrams below are a guide for all mounting points. SIDE VIEW SIDE VIEW Front View Side View FRONT VIEW Wall Cabinet Mounting point A and B need to be tighted TOP VIEW with slightly angled screws to pull the... -
Page 10: Flexi Ducting
4. Installation Overview NOTE: For more information, please refer to motor installation guide. 1. XDrive-600 Motor 2. Roof Seal Kit (Dektite)* 3. Support Straps* 4. Attach Flexi Duct to Bell- Mouth Adaptor using duct tape and cable tie. DO NOT rip the ducting. -
Page 11: Cooking With Induction Cooktops
5. Condensation Information Cooking with Induction Cooktops Cooking with an induction or similar cooktop, may produce condensation on the rangehood. Unlike basic electric or gas cooking, induction cooktops heat food and liquid instantly, which in turn, produces vapours rapidly. Because of this rapid process, the rangehood filters do not have enough time to warm, which increases the chance of condensation forming. -
Page 12: Troubleshooting
6. Troubleshooting Troubleshooting If the product does not work: Before you contact the service centre, make sure the product is plugged in, the electrical fuse (on selected models) is in correctly and electrical wiring is connected. Do not take any action that will damage the product. -
Page 13: Faulty Installation
Faulty Installation It is not the responsibility of Schweigen to rectify any incorrect installations. A service call out fee will be charged for any Schweigen technician that attends a call, whereby it is established that the fault is due to an incorrect installation or non-manufacturing fault. -
Page 14: Technical Specifications
8. Specifications DIMENSIONS EV-9UCQ 900mm EV-6UCQ 600mm Technical Specifications Model EV-6UCQ & EV-9UCQ Feeding Voltage 220-240V 50Hz Lamp Power 2 x 25W Approval Number Page 14... - Page 15 9. Disclaimer Disclaimer Under our policy of continuous product development, product specifications may change without notice. Prospective purchasers should therefore check with the retailer to ensure this publication correctly describes the products being offered for sale. All information supplied is to be used for general reference purposes only and is on the understanding that Scandium will not be liable for any loss, liability or damage of whatever kind arising as a result of any reliance upon such information.
- Page 16 Australia 8/3-4 Anzed Court, Mulgrave 3170 Victoria. Phone 1300 881 693 Email sales@schweigen.com.au Web www.schweigen.com.au New Zealand 5 Tolich Place, Henderson, Auckland 0610. Phone 0800 200 510 Email info.parex@emerson.com Web www.parex.co.nz...
Need help?
Do you have a question about the EV-6UCQ and is the answer not in the manual?
Questions and answers