Table of Contents
Advertisement
Service guide | Disassembling and Assembling VCM 46
Assembling
© Danfoss | DCS (im) | 2019.11
1. Lubrication:
•
To prevent seizing-up, lubricate threads
with PTFE lubrication type.
•
O-ring inside VCM 46 may be lubricated
only with clean filtered water.
•
O-rings at the thread end must be
lubricated.
•
It is important to lubricate ALL parts to
be assembled with clean filtered water.
3. Mount the water lubricated O-ring on the
cone. Ensure the O-ring is pushed fully into
the O-ring groove.
5. Mount the spring on the rod of the cone.
2. Mount the lubricated O-ring at the thread
end of the valve.
4. Mount the the cone.
6. Lubricate the threads of the nut.
180R9420 | AX323840049566en-000101 | 3
Advertisement
Table of Contents
Need help?
Do you have a question about the VCM 46 and is the answer not in the manual?
Questions and answers