Table Of Contents; Introduction; Instructions For Use; Installing The Remote Control - Philips SRU 5010/86 Instructions For Use Manual

Instructions for use

Contents
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
2. Installing the remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-6
Inserting the batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Testing the remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Setting the remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
3. Keys and functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
4. Extra possibilities . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Adding a function to the remote control . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Restoring the original functions of your remote control . . . . . . . . . . . . . 8
5. Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
6. Need help? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Code list of all brands / equipment . . . . . . . . . . . . . . . . . . . . . . . . . . 52-60
Information to the Consumer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 62

1. Introduction

Congratulations on your purchase of the Philips SRU 5010 universal remote
control. After installing the remote control it can operate the most-used
functions of almost any brand of TV.
You can find information about how to prepare this remote control for use in
the chapter 'Installing the remote control'.

2. Installing the remote control

Inserting the batteries

1
Press the cover inwards and slide it in
the direction of the arrow.
2
Place two AAA type batteries into the
battery compartment, as shown.
3
Slide the cover back and click it firmly into
place.
Note: If the LED blinks four times after every key press, the remote control is indicating
that its batteries are running low. Replace the old batteries with two new AAA
batteries.

Testing the remote control

The remote control has been programmed to operate the most-used
functions of almost any brand of TV. Because the SRU 5010 may use different
signals for each make and even for different models of the same brand, it is
advisable to test whether your TV responds to the SRU 5010.
The example below instructs you how to do this.
1
Turn your TV on manually or use the original remote control.
Tune to channel 1.
2
Check whether all the keys are working
For an overview of the keys and their
functions see '3. Keys and functions'.
- If the TV responds as it should to all of the
key commands the SRU 5010 is ready for use.
• If the TV does not respond at all or not to all of the key commands,
follow the instructions under 'Setting the remote control', or for
online setup go to: www.philips.com/urc.
4