Advertisement
Available languages
Available languages
Assembly Instructions for SIMATIC NET PROFIBUS SpliTConnect System
Assembling unused outputs
1. Close unused outputs with
nut (3), seal (5), sealing washer (8), shield
contact element (6) and strand holder (7).
Make sure they are fitted in the correct order.
Installation on a surface or DIN rail
1. To install on a flat surface or a DIN rail, fit the
assembled SpliTConnect tap (1) to the
SplitConnect clip (9).
Caution
The SpliTConnect tap is not intended as strain relief
for the PROFIBUS cable.
The cable must therefore be relieved of any strain
before it is connected!
Assembling the SpliTConnect coupler
1. Screw the SpliTConnect coupler (10) to a free
cable outlet of a SpliTConnect tap (1).
Caution! The contacting element (2) must first be
removed.
2. Screw the SpliTConnect coupler (10) to a free
cable outlet of a second SpliTConnect tap (1).
3. Screw the contacting elements (2) onto the
completely assembled SpliTConnect tap.
14
A5E03375783A-02
Advertisement
