Honda NC750X Manual page 144

Tire Puncture
u
Adjust the drive chain.
3.
Install and tighten the rear axle nut.
4.
Torque: 72 lbf·ft (98 N·m, 10.0 kgf·m)
Tighten the drive chain adjusting nuts
5.
lightly, then hold the adjusting nuts and
tighten the lock nuts.
Torque: 15 lbf·ft (21 N·m, 2.1 kgf·m)
After installing the wheel, apply the brake
6.
pedal several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
142
Removing Wheels
P. 116
2
7.
NC750XD
Install the parking brake caliper and
tighten the mounting bolts.
Torque: 23 lbf·ft (31 N·m, 3.2 kgf·m)
Take care to prevent the brake caliper
u
from scratching the wheel during
installation.
Use new mounting bolts when
u
installing the parking brake caliper.
NOTICE
When installing a caliper into original position, carefully fit the
brake disc between the pads to avoid scratching them.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.