Electrolux EHG30200 User Manual page 11

Liquid gas
Use the rubber pipe holder for liquid gas.
Always engage the gasket. Then continue
with the gas connection.
The flexible pipe is prepared for apply
when:
– it can not get hot more than room tem-
perature, higher than 30°C;
– it is no longer than 1500 mm;
– it shows no throttles;
– it is not subject to traction or torsion;
– it does not get in touch with cutting
edges or corners;
– it can be easily examined in order to
make sure its condition.
The control of preservation of the flexible
pipe consists in checking that:
– it does not show cracks, cuts, marks of
burnings on the two ends and on its full
length;
– the material is not hardened, but shows
its correct elasticity;
– the fastening clamps are not rusted;
– expired term is not due.
If one or more defects are visible, do not
repair the pipe, but replace it.
When installation is complete,
make sure that the seal of each
pipe fitting is correct. Use a soapy
solution, not a flame!
8.2 Injectors replacement
1.
Remove the pan supports.
2. Remove the caps and crowns of the
burner.
3. With a socket spanner 7 remove the
injectors and replace them with the
ones which are necessary for the type
of gas you use (see table in "Techni-
cal Information" chapter).
4.
Assemble the parts, follow the same
procedure backwards.
5. Replace the rating plate (it is near the
gas supply pipe) with the one for the
new type of gas supply. You can find
this plate in the package supplied
with the appliance.
If the supply gas pressure is changeable
or different from the necessary pressure,
you must fit an applicable pressure ad-
juster on the gas supply pipe.
8.3 Conversion into Town Gas
• Auxiliary and semi-rapid burner: after
you assemble the injectors (A ), screw
on the nuts with the diameter of 10 mm
(B1),included in the supply (primary air
regulators) ;
• Rapid burner: after assemble the injec-
tors (A ), screw on the nuts with the di-
ameter of 16 mm (B2), included in the
supply (primary air regulators) ;
C
B2
B1
A
When you assemble each burner,
use the special cap tool (C) and a
screwdriver to prevent damage to
the nuts.
Be sure to remove the cap tool
before reassembling the burners.
8.4 Adjustment of minimum level
To adjust the minimum level of the burn-
ers:
1. Light the burner.
2.
Turn the knob on the minimum posi-
tion.
3. Remove the knob.
4. With a thin screwdriver, adjust the by-
pass screw position.
ENGLISH 11