Technical Specifications - Philips SHC8680/61 Instructions For Use Manual

SHC8680new.qxd 04-05-2005
Transmitter
Receiver Unit
10:24 Pagina 13
Receiver unit too far away from
transmitter
Transmitter other than
SHC8680 is used

Technical specifications*

System:
Modulation:
Pilot Tone:
Carrier Frequency: (/00 & /05)
Radiated Output Power:
Effective Transmission Range:
Input Level:
Power supply:
Reception Frequency: (/00 & /05)
S/N ratio:
Distortion:
Channel Separation:
Audio frequency range:
Power Supply:
Battery Life Time:
* All specifications are subject to change
** Depending on ambient conditions
European Regulations
Hereby, Philips Consumer Electronics, B.U. Peripherals & Accessories,
declares that this FM wireless headphone system SHC8680 is in
compliance with the essential requirements and other relevant provisions
of Directive 1999/5/EC.
This product has been designed, tested an manufactured according to the
European R&TTE Directive 1999/5/EC.
ENGLISH 13
Move closer for reception
Make use of the SHC8680
transmitter provided. Some
transmitters already built into other
equipment may not be compatible
with the SHC86880 receiver unit
because of the advanced
technologies used.
Radio Frequency (RF)
Frequency Modulation (FM)
19kHz
Channel 1: 863.5MHz
Channel 2: 864MHz
Channel 3: 864.5MHz
<10mW
Up to 60m **, omni directional
(360°)
500 mV
12 Volts/ 200mA DC, center positive;
type number: SBC CS030/00
(/05 for UK, Ireland)
863MHz – 865MHz
> 60dB (1kHz sine wave, A-weighted)
2% THD
30 dB
20-20,000 Hz
1 x AA rechargeable battery (Philips,
NiMH, type number: AY 3362,
partnumber 310330884711)
~ 10 hours