Philips SHC8680/61 Instructions For Use Manual page 12

SHC8680new.qxd 04-05-2005
12 ENGLISH
No sound/
distorted sound
10:24 Pagina 12
Receiver unit power off
No battery installed
Wrong battery orientation
No power supply to transmitter
Battery power running low
Audio source not connected
Audio source is off
Volume level set too low
Audio output level low
Receiver unit not tuned to
the transmitter
Interference from other
radio sources
Switch on the POWER button of the
receiver unit. The POWER STATUS
light will be illuminated in red.
Follow step 1 to 4 of
'Installing/replacing the batteries'
Reposition the batteries according to
the engraved polarity symbol.
Make sure the docking station is
connected to the local mains power
supply through an adapter and follow
step 5 to 7.
Follow step 8 to 12 to recharge the
receiver unit.
Make sure the audio output of your
audio source is connected to the
3.5 mm stereo LINE IN jack of your
transmitter.
Follow step 13 and 14.
Turn on your audio source.
Adjust the volume level of your
audio source or the receiver unit.
Hearing Safety: Continuous use at a
high volume may permanently damage
your hearing.
In case of audio sources with
adjustable output level, adjust the
output level to a higher and
non-distorted level.
IMPORTANT: In case of certain TVs,
the headphone jack output level can
only be adjusted after accessing the TV
on-screen menu.
Push and hold the AUTO-TUNING
button for about 1 sec, then the
receiver unit will automatically
search for the best possible
reception.
1) Alter the transmitter's frequency
channel. Select 1 of the 3 options for
best reception.We advise you to
select channel 1 as the first option.
Next adjust the receiver unit's tuning
channel as described above.
2) Move transmitter or receiver unit
elsewhere