Step 1-5 Preparing Materials And Tools - Samsung AR TSFA Series Installation Manual

Table of Contents

Advertisement

Preparation

Step 1-5 Preparing materials and tools

Materials in the indoor unit package
Make sure that the indoor unit package contains the following
materials:
Mounting bracket (1)
**07*******
**09*******
**12*******
**15*******
Remote control (1)
Quick Guide for User (1)
Extra M4 x 12 tapping
screw (2)
Materials in the outdoor unit package
Make sure that the outdoor unit package contains the
following materials:
Rubber foot (4)
12
English
Mounting bracket (1)
**18*******
**24*******
Remote control battery (2)
Quick Guide for Installer (1)
Drain plug (1)
If using a multi system, install as described in the
installation manual supplied with the outdoor unit.
Optional accessories
For information on the accessories that are available for each
model, see the submittal documents listed on page 3.
Materials supplied by the installer
Make sure you have all other materials required for the
selected installation method and location.
IMPORTANT
No mounting hardware, tubing, cables, and other
materials listed below are included with the appliance.
The required materials will vary, but may include the
following:
6-ft electrical whip for connecting the power from the
installed disconnect switch to the outdoor unit
UV-resistant vinyl line set tape for the exposed line set
Lines-set cover and fittings, if used
Miscellaneous pipe hangers
Miscellaneous screws and anchors for hanging pipe
hangers, the line-set cover, the indoor unit mounting
plate, and so on.
Electrical ring connectors for connecting all power and
communication wiring
Electrical tape
Refrigerant R-410A if additional refrigerant is required
due to line-set length
Closed cell foam tape insulation (roll)
Outdoor unit risers or L-brackets for wall installation
Silicone caulking for sealing the wall penetration
Rags
Piping and cables
Connecting the indoor and outdoor units requires a
premanufactured refrigeration line set (recommended) or a
line set assembled by the installer that includes.
Soft-copper line set insulated with closed-cell foam
insulation
18 shielded cable, for communication (F1/ F2) wiring
14/3 flexible metallic underground cable with green grounding
wire, for power wiring from the outdoor unit to the indoor unit
5/8-inch ID drain hose with adapter fitting, for gravity
drain applications that require an extension

Advertisement

Table of Contents
loading

Table of Contents