Advertisement
4.9
Remote control operation.
The remote control provides the
same functionality as the main
control panel except for the
Warm/Cool Air Flow Control
Lever which must still be moved
manually.
4.9.1 Insert the two AAA batteries
supplied into the compartment
in the back of the remote
control ensuring that they are
the right way round.
4.9.2 In use, point the remote control
at the main control panel on the
unit.
4.9.3 Ensure that the main unit is
plugged into the mains socket.
4.9.4 Set the Warm/Cool Air Flow
Control lever on the unit to the
desired mode.
4.9.5 Turn the unit on by pressing the
ON/OFF button on the handset.
4.9.6 Select 'WARM' or 'COOL' as
required on the handset.
4.9.7 Select the fan speed as
required.
4.9.8 Press 'WIND' if you require side
to side oscillation of the air flow.
4.9.9 The timer functions in the same
way as described in section
4.2.2. To cancel timer settings
advance the time to 7.5 hours
and press the timer button once
more to cancel the settings.
5. MAINTENANCE
5.1
General Maintenance. Turn the unit OFF
and disconnect it from the mains power
supply before cleaning or performing any
maintenance.
5.1.1 Inspect the unit on a regular basis and
replace or repair any damaged parts. Use
recommended parts and an authorised
service agent. Unauthorised parts may be
dangerous and will invalidate the warranty.
5.1.2 Do not use any solvents or abrasive material
to clean the plastic exterior of the unit. Use
only a damp soft cloth for cleaning and dry
the unit afterwards with a clean,dry, soft cloth.
5.2
Air Filter. Clean the air filter every 20 to 30
days for optimum performance. The filter is
in the back of the unit, held in place by a
plastic frame which is secured by a screw at
the top centre of the frame.
5.2.1 Remove the retaining screw. Take hold of
the plastic frame directly below the screw
fixing and pull the frame outwards to remove
it. Remove the filter from the back of the frame and shake it outdoors to remove dust. If the filter is very dirty it
can be washed in warm water contaning a mild, neutral detergent. Ensure that the filter is completely dry before
using it again.
5.2.2 To replace the filter first insert the two tags 'C' on the filter frame into the bottom edge of the filter frame recess.
Lay the filter onto the filter frame and hinge the frame forwards into the recess. Push the top of the frame
inwards until the two clips 'A' snap into place. Push the frame inwards at points 'B' on the sides of the frame until
they too snap into place. Replace retaining screw.
Fig.4
Fig.5
SAC41 - 1 - 05/12/06
Advertisement
