Page 1
( ) depress trigger and depress completely to trigger until initiate arc wire comes out. See chart on welder for correct settings Replace consumables FIND MORE INFORMATION AT FORNEYIND.COM QUESTIONS OR TROUBLE? Contact Forney Industries at 1-800-521-6038 customerservice@forneyind.com forneyind.com...
Page 2
MIG TROUBLESHOOTING TIPS Workpiece grounding Workpiece Preperation Connect ground clamp to clean, bare metal. No rust, To ensure maximum quality, always clean paint or other coatings. Attach the ground clamp and prepare welding surfaces. directly to the workpiece if you are experiencing issues. Frequently tripping circuit breaker or exceeding duty cycle Use wire with a diameter between 0.023”...
Page 3
• Generators must be a minimum 10,000W continuous output with no low-idle • Generators must be a minimum 5,000W continuous output with no low-idle function function (or low-idle off), 5% THD Max. (or low-idle off), 5% THD Max. QUESTIONS OR TROUBLE? Contact Forney Industries at 1-800-521-6038 customerservice@forneyind.com forneyind.com...
• Generators must be a minimum 10,000W continuous output with no low-idle function • Generators must be a minimum 5,000W continuous output with no low-idle function (or low-idle off), 5% THD Max. (or low-idle off), 5% THD Max. QUESTIONS OR TROUBLE? Contact Forney Industries at 1-800-521-6038 customerservice@forneyind.com forneyind.com...