Advertisement
1
Figure 2
1. Ramp handle
5. Raise and lock ramp. Adjust locking brackets so they
are engaged on pins and tighten flange screws and nuts
(Fig. 1 & 3).
1
3
Figure 3
1. Locking bracket
2. Load ramps
6. Remove fasteners securing trailer stops to each side of
trailer and move backward to next set of holes and
re–install (Fig. 1).
7. Remove existing wheel rods and brackets from each
side of trailer (Fig. 1).
8. Mount new smaller wheel rods to front and rear sets of
mounting holes in each side of trailer, using brackets
and fasteners removed (Fig. 1).
Note: On trailers with serial numbers prior to 220000001,
(2) new rod brackets, part no. 105–5395 and (2) new
retaining clips, part no. 99–6204 must be purchased to
replace existing components on trailer.
Note: When trailering only one greensmower, mount
wheel rods to middle set of mounting holes in trailer.
2
2. Grind here
2
3. Ramp
9. Remove existing standard transport wheels from wheel
shafts on greensmower (if so equipped).
Figure 4
1. Wheel shaft (L.H. shown)
2. Wheel
10. Insert a wheel onto each shaft and secure with a wheel
clip (Fig. 4).
2
3
1
2
3. Wheel clip
Advertisement
