Page 1
SUN COTBED BELANGRIJK / IMPORTANT RETAIN FOR FUTURE REFERENCE READ CAREFULLY The illustrations in these instructions are to be used as a guide only Conforms to EN 716-1&2:2008, BS 8509:2008 Voldoet aan 716-1&2:2008, BS 8509:2008 Conform à 716-1&2:2008, BS 8509:2008...
Page 2
SAFETY INSTRUCTIONS - COT Your child’s safety is your resposibility. Remove all parts from packaging and check against the parts list. Do not discard any packaging until you are sure you have all parts and the pack of fittings. You will find it easier to assemble the cot if a second adult is available to help you. WARNING : Be aware of the risk of open fires and other sources of strong heat, such as electric bar fires, gas fires etc in the near vicinity of the cot WARNING : Do not use if any part of the cot is broken, torn or missing...
Page 3
Belangrijk BELANGRIJK: LEES ALVORENS TE MONTEREN AANDACHTIG DE GEBRUIKSINSTRUCTIES EN BEWAAR ZE ZORGVULDIG VOOR LATER GEBRUIK. Kies een matras met afmeting 140 x 70 cm en dikte van ca. 10 cm zodat de interne hoogte (vanaf de bovenkant van de matras tot bovenkant bed) ten minste 500 mm bedraagt in de laagste positie en ten minste 200 mm in de hoogste positie...De matras, met de bodem in zijn hoogste stand, mag niet hoger komen dan de markering aan de...
Page 4
Parts list / Inhoud van de doos / Contenu de la bo te Parts list / Inhoud van de doos / Contenu de la bo te...
Page 5
Assembling / bevestiging / assemblage Attach ends to cot’s legs using screws Ax8. Do not tighten. Bevestig de korten kanten op de poten met vijzen A x 8. De vijzen niet aanspannen. Attachez les petits c tés sur les jambes avec les vis A x 8. Ne pas serrer les vis.
Page 6
SAFETY INSTRUCTIONS - BED Your furniture may be cleaned by wiping with a damp cloth and drying with a soft clean cloth. Do not use abrasives, bleach, alcohol or ammonia-based household polishes. Take care when handling or moving the furniture. Careless handling may cause damage. For ages 18 months to 4 years.
Page 7
Assembling / bevestiging / assemblage Attach cot’s end to legs using screws Ax4. Do not tighten screws. Attach side-crossbeams to ends using screws Ax8. Do not tighten screws A. Attach mattress base to side-crossbeams using screws Bx4 and spacers Cx4. Attach mattress base to cot’s ends using screws Bx4.
Need help?
Do you have a question about the SUN and is the answer not in the manual?
Questions and answers