Connecting To Your Tv - Philips SDV2940/55 User Manual

Connecting to Your TV

EN
Before
You
Start
22
For this antenna to work properly, you must access the menu
on the television you are connecting this antenna to (consult
your television owner's manual) then set it to receive the
signal from an ANTENNA instead of CABLE or SATELLITE.
Connections to your TV
fig.7
As previously noted the amplifier (Power Injector + Power supply)
must be placed in-line between the antenna and before any splitter
or additional devices.
1. Connect the coaxial cable from the antenna to the F connector
labeled ANT on the Power Injector.
2. Connect Power Injector to the antenna input on your TV,
Splitter and / or any other device.
3. Connect the Power Supply DC plug to the Power Injector then
plug the power supply adapter into a 100-240V AC receptacle.
Safety Note - The power injector and power supply is for indoor
use only!
Alternate connections
1. If your TV has separate inputs for UHF and VHF you will need
to purchase a signal splitter that will separate the two different
signals.
2. If your TV has only two screw type antenna inputs you will need
to purchase a 75 Ohm to 300 Ohm transformer.
A note about coaxial cable – Your SDV2940 includes a 20 foot roll
of RG-59 coaxial cable. If you should find that this is not adequate
for your needs we recommend for best possible signal integrity that
you do not extend this cable. A better choice is to replace the cable
with either RG-6 or RG-6 Quad Shield cable. Both of these cables
are designed for minimal signal loss over longer cable runs. This will
ensure the best possible picture and overall performance.