Table of Contents
Advertisement
Page 26 of 27
4.6. Adjust the height of the platters
To move the platters (lift them or lower them), steps 10 – 17 need to be done again.
4.6.1. Lifting the platters
Screw the needle-screw until the needle touches the top of the spindle. Use Allen
wrench to hold the needle-screw in this place while unscrewing the upper cylinder counter-
clockwise using the adjustable wrench. Do not rotate the needle-screw, just hold it in the
same position. This will assure that the spindle stays in place while the platter carrier ("the
hat") gets lifted. Since usually only slight adjustments are needed, a quarter of turn (1/4)
should be enough to lift the platters from the spacers.
4.6.2. Lowering the platters
Screw the bottom cylinder until it touches the hard drive from the bottom (same as
in step 19.). After this, screw the spindle-pushing screw in the bottom cylinder until it hits
the bottom of the bearing on hard drive. This will assure that the bearing stays in place
while the platter carrier ("the hat") gets lowered. Using the adjustable wrench, screw the
upper cylinder (turn it clockwise) to lower the platters. A quarter of turn (1/4) should be
enough for slight adjustment.
HDDSURGERY
Lomina 33, 11 000 Belgrade, Serbia
phone +381 11 361 43 43
www.hddsurgery.com
support@hddsurgery.com
Tools for data recovery experts
Advertisement
Table of Contents
