Placing The Donor Bearing In A Patient Hard Drive - HddSurgery Seagate 7200.10 Manual

Page 16 of 27

Placing the donor bearing in a patient hard drive

25. Pull out the needle from the bearing by unscrewing the needle-screw in the upper
cylinder. Remove the screw from the cocoon, place the donor bearing in it, and then
place the cocoon with bearing in the bottom cylinder.
26. Screw the bottom cylinder with cocoon and bearing by hand to ensure that the bearing
goes straight. Push the bearing this way until the cocoon hits the bottom of the hard
drive. When this happens, unscrew the bottom cylinder and remove the cocoon from it.
Screwing the bottom cylinder with cocoon and bearing
27. If the cocoon stays on the bearing, use the screw to remove it from the bearing. Screw
this screw in the hole on the cocoon and pull it to remove the cocoon from the bearing.
28. Turn the tool upside down and apply super glue to the visible part of the bearing.
HDDSURGERY
Lomina 33, 11 000 Belgrade, Serbia
phone +381 11 361 43 43
www.hddsurgery.com
support@hddsurgery.com Tools for data recovery experts