Page 12 of 27
19. When the hard drive is in place and firmly attached to the tool from the upper side, turn
the tool upside-down and screw the bottom cylinder until it touches the bottom side of
hard drive.
20. Screw the clamping nut on the bottom cylinder until it touches bottom side of the tool.
Tighten the screw on the clamping nut. Place another clamping nut on the cylinder also.
Affixing the clamping nut on the bottom cylinder
HDDSURGERY
Lomina 33, 11 000 Belgrade, Serbia
phone +381 11 361 43 43
www.hddsurgery.com
support@hddsurgery.com
Screwing the bottom cylinder
Tools for data recovery experts