Advertisement
Fig. 15: Connecting the throat plate slide interrogator (5)
(11) - Plug connection X2-X5
(12) - Plug connection X6 (IN)
8. Connect the cable of the throat plate slide interrogator at any available
9. Connect the corresponding slot on the machine distributor (depending
10. When the circuit board (8) is connected to the machine, connect plug
11. Set all DIP switches (13) whose slots X1-X5 are NOT occupied to
Information
The ON position of the DIP switches signifies that no interrogator is
connected at the corresponding slot or that the function of the respective
interrogator is switched off.
The DIP switches (13) shown in the figure below MUST be set to the
The needle cover interrogator has been successfully assembled and
Proceed by testing the functionality of the throat plate slide interrogator
( p. 15).
14
⑪
slot X2/X3/X4/X5 (11).
on the machine) to plug connection X6 (12).
connection X13 (9) with plug connection X1 (14).
position ON.
following position:
• DIP switch 1: ON
• DIP switch 2: OFF
• DIP switch 3: OFF
• DIP switch 4: ON
• DIP switch 5: ON
connected.
Connecting the throat plate slide interrogator
(13) - DIP switch 1-5
(14) - Plug connection X1
Additional Instructions 867 M-TYPE - 00.0 - 05/2018
⑭
⑬
⑫
Advertisement
