Hints For Optimum Use - Black & Decker BDH1850SM Instruction Manual

SmartSelect
TM
The steam mop is equipped with a SmartSelect
surface cleaning applications. They are used to select the correct operating mode for
your particular hard floor surface.
WARNINg:
surfaces that have been treated with wax or some no wax floors, the sheen may be
removed by the heat and steam action. It is always recommended to test an isolated
area of the surface to be cleaned before proceeding. We also recommend that you
check the use and care instructions from the floor manufacturer.
Using the SmartSelect
The steam mop will select the correct volume of
steam required for your particular cleaning operation.
NOTICe:
The SmartSelect
on will recall the previously used setting.
STeAM BURST BUTTON
The steam burst button is built in feature that aides in the removal of stubborn floor marks or
stuck on grime.
• To apply an extra burst of steam to trouble areas, press the Steam Burst button (23).
NOTICe:
The steam burst will last for 10 seconds then the steam mop will return to
the chosen setting.
NOTICe:
This unit will kill 99.9% of bacteria and germs when used in accordance with
this manual and with the micro fiber pad fitted and a continuous run time of 90 seconds
geNeRAL USe
CAUTION:
Never use the steam mop without first attaching a cleaning pad.
CAUTION:
It is important to monitor the water level in the water tank. To refill the
water tank and continue to sanitise/ clean, return the handle tube (4) to the upright
position and turn the steam mop 'OFF'. Unplug the unit from the electrical wall outlet, and
refill the water tank with supplied water jug.
CAUTION:
Never leave the steam mop in one spot on any surface for any period of
time. Always place the steam mop on the resting mat (7) with the handle tube in the upright
position when stationary and make sure the steam mop is turned off when not in use.
• Always vacuum or sweep the floor before using the steam mop.
• The easiest way to use the steam mop is to tilt the handle to a 45˚ angle and clean
slowly, covering a small area at a time.
• Do not use chemical cleaners with your steam mop. To remove stubborn stains
from vinyl or linoleum floors, you can pre-treat them with a mild detergent and some
water before using the steam mop.
STeAM MOP CLeANINg
• Place a cleaning pad (6) on the floor with the 'hook & loop' side facing up.
• Raise the steam mop off the resting mat and lightly press it down onto the cleaning pad.
• Place the steam mop on the resting mat.
• Plug the steam mop electric cord into the outlet.
Dial - fig. N
Do not use on any unsealed hard floor surfaces. Additionally, on
dial (2), choose from one of the following applications:
TM
TM
Dial has a memory function. Switching the steam mop

hINTS fOR OPTIMUM USe

dial (2) which shows various hard floor
TM
N
2
8
23