Sapir SP-1810P Instruction Manual page 3

recharging holder, then plug the AC adaptor into the AC outlet , and it begins to recharge the
battery. The clipper can work for about 60 minutes after being recharged for 8 hours.
Use
Simply push the switch to ON position and the clipper will start working.
Using comb attachment
Put the comb attachment into the grooves on both sides of housing, hold the clipper with
downside upwards and select the cutting length you want. This hair clipper has 2 comb
attachments.
A: 8, 12, 16,20mm; B: 24, 28, 21, 36,40mm
Blade maintenance
Hold the Clipper with the obverse side facing downwards. Push the blade to make it apart
from the housing. Clean the blade with the cleaning brush and then press the cleaning lever to
open the blade and sweep away hair that remained between the blades. After that, put 2 or 3
drops of oil between the blades to lubricate them. It is necessary to clean and lubricate the
blade after every few times uses to keep the clipper in good condition. Following the
procedure that reverses the above to reassemble the clipper, push the blade until it firmly
clicks into position.