Prior To Operation - DeWalt DWE7491 Original Instructions Manual

WARNING:
• Never place your hands near the
cutting area.
• Place your hands no closer than
150 mm from the blade.
• Do not cross your hands.
• Keep both feet firmly on the floor and
maintain proper balance.

Prior to Operation

WARNING:
• Install the appropriate saw blade.
Do not use excessively worn blades.
The maximum rotation speed of the
tool must not exceed that of the saw
blade.
• Do not attempt to cut excessively
small pieces.
• Allow the blade to cut freely. Do not
force.
• Allow the motor to reach full speed
before cutting.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
The attention of UK users is drawn to the
"woodworking machines regulations 1974" and any
subsequent amendments.
Ensure the machine is placed to satisfy your
ergonomic conditions in terms of table height and
stability. The machine site shall be chosen so that
the operator has a good overview and enough free
surrounding space around the machine that allows
handling of the workpiece without any restrictions.
To reduce effects of increased vibration, make sure
the environment is not too cold, the machine and
accessory are well maintained and the workpiece
size is suitable for this machine.
WARNING:
• Always observe the safety instructions
and applicable regulations.
• Ensure the machine is placed to
satisfy ergonomic conditions in terms
of table height and stability. The
machine site shall be chosen so that
the operator has a good overview
and enough free surrounding space
around the machine that allow
handling of the workpiece without any
restrictions.
• Install the appropriate saw blade.
Do not use excessively worn blades.
The maximum rotation speed of the
tool must not exceed that of the saw
blade.
• Do not attempt to cut excessively
small pieces.
• Allow the blade to cut freely. Do not
force.
• Allow the motor to reach full speed
before cutting.
• Make sure all locking knobs and
clamp handles are tight.
• Never place either hand in the blade
area when the saw is connected to
the electrical power source.
• Never use your saw for freehand
cuts!
• Do not saw warped, bowed or
cupped workpieces. There must be
at least one straight, smooth side
to go against the rip fence or mitre
fence.
• Always support long workpieces to
prevent kickback.
• Do not remove any cut-offs from the
blade area while the blade is running.
Switching On and Off (fi g. 13)
The on/off switch (h) of your saw bench offers
multiple advantages:
• No-volt release function: should the power be
shut off for any reason, the switch has to be
deliberately reactivated.
• To switch the machine on, press the green start
button.
• To switch the machine off, press the red stop
button.
ENGLISH
45