Ryobi EMS-2431SCL User Manual page 23

GB
F D
ADJUSTMENTS
CAUTION
Do not stare directly at the laser beam.
Never aim the beam at any person or an object
other than the workpiece. Always ensure the
laser beam is aimed at a sturdy workpiece
without re.ective surfaces.
OPERATIONS
BEFORE MAKING A CUT
Inspect your workpiece. Make sure there are no nails or
foreign objects in the workpiece to be cut.
CAUTION
Because of the sliding action of this saw,
this machine is not designed for cutting metals.
Use this mitre saw to cut only wood and wood like
products. Other materials may shatter, bind on the
blade, start fire or create other dangers.
BODY AND HAND POSITION
Never place hands near cutting area. Place hand at
■
least 100mm from path of blade.
Hold workpiece firmly to the fence to prevent
■
movement toward the blade.
When holding the work piece to the left side of the
■
blade, always use your left hand. Use your right hand
to hold the work piece to the right side of the blade.
Before making a cut, make a "dry run" with the power
■
off so you can see the path of the blade.
Keep hands in position until trigger has been released
■
and the blade has completely stopped.
WARNING
Before starting any cutting operation, clamp or
bolt the compound mitre saw to a workbench.
Never operate the mitre saw on the floor or in a
crouched position. Failure to heed this warning
can result in serious personal injury.
WARNING
To avoid serious personal injury, always tighten
the mitre lock knob securely before making a cut.
Failure to do so could result in movement of the
control arm or mitre table while making a cut.
E I P NL S DK N FIN
English
WARNING
When using a work clamp or C-clamp to secure
the workpiece, clamp workpiece on one side of
the blade only. The workpiece must remain free
on one side of the blade to prevent the blade
from binding in workpiece. The workpiece
binding the blade will cause motor stalling and
kickback. This situating could cause an accident
resulting in possible serious personal injury.
CROSS-CUTTING (WITH SLIDE ACTION)
(Fig. 12)
A mitre angle of up to 55° left or right can be obtained
■
using this saw.
Pull out the lock down pin (14) and lift the saw head
■
to its maximum height.
Loosen the mitre lock knob (9).
■
Press and hold mitre lock handle (5).
■
Turn the table until the mitre pointer (A) (Fig. 6)
■
reaches the desired angle.
NOTE: You can quickly locate 0°, 15°, 22.5°, 30° &
45° left or right on the scale. The mitre table can be
seated in one of the positive stop notches, located in
the base.
Release the lever (5). Tighten the knob (9) to hold the
■
table in position.
Switch on the laser (1).
■
Lay the workpiece on the table against the fence and
■
adjust its position so that the pencil mark is on the
laser line.
Use the vice (12) to secure the workpiece.
■
Loosen the slide lock knob (21).
■
Grasp the operating handle (25) and pull the blade to
■
the foremost position.
Squeeze the power trigger (3) and allow the saw to
■
reach full speed.
Press and hold the lower guard release lever (20).
■
Push the saw handle (25) all the way down and cut
■
through the leading edge of the workpiece.
Gently push the saw towards the fence (13) until it
■
reaches the aftermost position.
Release the trigger (3) and allow the saw to stop
■
completely before raising the blade out of the
workpiece.
DANGER
NEVER pull the saw toward you during a cut.
The blade can suddenly climb up on top of the
workpiece and force itself toward you.
16
GR H CZ RUS RO PL