Ryobi EMS-2431SCL User Manual page 20

GB
F D
OTHER SAFETY PRECAUTIONS FOR USING
SLIDING COMPOUND MITRE SAW
Laser type: Semiconductor
Laser class: 2
Wave length: 650 nm
Power supply: 3 V
Laser power: < 1 mW
For service personnel.
CAUTION: Avoid exposure to beam when servicing.
Complies with EN60825-1:1994+ A2:2001+ A1:2002 as a
Class 2 Laser.
WARNING
Do not stare directly at the laser beam.
A hazard may exist if you deliberately stare into the
beam, please observe all safety rules as follows.
The laser shall be used and maintained in
■
accordance with the manufacturer's instructions.
Never aim the beam at any person or an object other
■
than the workpiece.
The laser beam shall not be deliberately aimed at
■
personnel and shall be prevented from being directed
towards the eye of a person for longer than 0.25 s.
Always ensure the laser beam is aimed at a sturdy
■
workpiece without reflective surfaces, i.e. wood or
rough coated surfaces are acceptable. Bright shiny
reflective sheet steel or the like is not suitable for
laser use as the reflective surface could direct the
beam back at the operator.
Do not change the laser light assembly with a
■
different type. Repairs must be carried out by
authorised Ryobi service centre.
FEATURES
1. Laser on/off switch
2. Laser
3. Trigger
4. Lower blade guard
5. Mitre lock handle
6. Throat plate
7. Bevel scale
8. Material support arm
9. Mitre lock knob
10. Mitre scale
11. Mitre table
12. Vice or workpiece clamp
13. Rear fence
E I P NL S DK N FIN
English
14. Lock down pin
15. Spindle lock button
16. Bevel lock button
17. Dust bag
18. Upper blade guard
19. Base
20. Lower guard release lever
21. Slide lock knob
22. Sliding gear assembly
23. Connecting Bar
24. Brush Cap
25. Handle
26. Carrying handle
27. Depth stop knob
CROWN MOLDING FLAT ON MITRE TABLE (Fig. 15)
28. CEILING
29. WALL
30. TOP EDGE AGAINST FENCE =
LEFT SIDE, INSIDE CORNER
RIGHT SIDE, OUTSIDE CORNER
31. INSIDE CORNER
32. OUTSIDE CORNER
33. BOTTOM EDGE AGAINST FENCE =
RIGHT SIDE, INSIDE CORNER
LEFT SIDE, OUTSIDE CORNER
LOOSE PARTS LIST
34. Dust bag
35. Vice or workpiece clamp
36. Material support arm x 2
37. Box Spanner
38. Lower blade guard assembly
SPECIFICATIONS
Power Input
No Load Speed
Blade Diameter
(Ø 315 mm x Ø 30 mm x 48 T)
Blade Arbor
Weight
Cutting Capacity
Mitre 90° x Bevel 90°
Mitre 45° (R) x Bevel 90°
Mitre 45° (L) x Bevel 90°
Mitre 90° x Bevel 45°
Mitre 45° (R) x Bevel 45°
Mitre 45° (L) x Bevel 45°
13
GR H CZ RUS
(
Fig. 2)
2400 watt
4200 min-
315 mm
30 mm
25 kg
110 mm x 300 mm
110 mm x 210 mm
110 mm x 210 mm
70 mm x 300 mm
70 mm x 210 mm
70 mm x 150 mm
RO PL
1