Batteries - Kane 425 Manual

1. BATTERIES

Battery Type
This analyser has been designed for use with disposable alkaline batteries or
rechargeable Nickel Metal Hydride (NiMH) batteries. No other battery types
are recommended.
WARNING
The battery charger unit must only be used when NiMH batteries are fitted.
Replacing Batteries
Turn over the analyser, remove its' protective rubber sleeve and fit 4 "AA"
batteries in the battery compartment. Take great care to ensure they are fitted
with the correct battery polarity. Replace the battery cover and protective
rubber sleeve.
Switch the analyser on and select "Status" to check that the analyser's time and
date are correct. To reset see USING THE MENU, Section 5.
Charging NiMH Batteries
Ensure that you use the correct charger. The part number is KMCU250/UK.
To fully charge NiMH batteries:
The KANE425 must be switched on.
The charger must then be connected and switched on.
When charging the red Battery Charging Indicator will illuminate.
When the KANE425 is switched off the display will show "BATTERY
CHARGING"
The first charge should be for 12 hours continuously. NiMH batteries are
suitable for top up charging at any time, even for shorts periods.
An in-vehicle charger can be used to top up the analyser's batteries from a 12
volt vehicle battery. The part number is KMCU450/12
Battery Disposal
Always dispose of depleted batteries using approved disposal methods that
protect the environment
KANE425 manual Page 7