Kane 425 Manual page 11

Backlight &
Press
Torchlight
and off.
NOTE: Use of the backlight/torchlight increases the
current drain on the batteries
Switching
The analyser normally operates with the pump on. Press
PUMP on /
to switch the pump off and on.
off
When the pump is switched off "---PO--" is displayed instead
of the O
"PUMP OFF" on the top line approx every 40 seconds.
NOTES:
1) The pump will not switch off if the CO reading is above
20ppm . This helps to protect the CO sensor from damage.
2) The pump will automatically switch itself off when the
rotary switch is set to Menu, Status, Pressure, Tightness or
Differential Temperature.
Zeroing the
Press and hold
pressure
CAL ZERO.
sensor
Printing Data
Press and quickly release
The analyser displays a series of bars until this is completed.
Press and release the key again to abort printing.
Make sure the printer is switched on, ready to accept data and
its' infrared receiver is in line with the analyser's emitter (on
top of the analyser).
to switch the display's backlight and torchlight on
, CO & Ratio readings. The analyser also displays
2
until the top line display shows
KANE425 manual
to start the analyser printing.
Page 11