Advertisement
Optional ISW-ACC665 Swivel Bracket
Installations that require the back tamper cannot use
the ISW-ACC665 Swivel Bracket.
The ISW-ACC665 Swivel Bracket is sold separately.
Figure 4: ISW-ACC665 Swivel Bracket Options
1
1 -
Ceiling mount installation
2 -
Wall mount installation
To mount the swivel bracket:
1.
Remove the PCB from the transmitter housing.
Figure 5: Removing the PCB
2.
Connect the transmitter housing to the swivel bracket.
Figure 6: Housing Back Plate
3.
Re-install the PCB into the transmitter housing.
© 2009 Bosch Security Systems, Inc.
2
ISW-EN1261HT Installation Guide
6.0
Test the Detector
To ensure correct operation, test the detector after it
is registered with the system receiver. To test the
detector, activate each of the conditions and ensure
an appropriate response.
Performing a walk test ensures that the detector senses motion and
sends an alarm signal.
To perform a walk test:
1.
Swipe a magnet near the Test Reed switch to start a 5-min walk
test. Refer to Figure 2 on page 1.
2.
Walk in front of the detector.
Each time motion is detected, the LED on the front of the
detector blinks, and the detector sends an alarm signal.
After 5 min, the walk test automatically ends.
Figure 7: Coverage Pattern
13 ft
16 m
14 m
12 m
10 m
8 m
6 m
4 m
2 m
0 m
4 m
6 m
0 m
2 m
13 ft
4 m
2.4 m
2 m
0 m
4 m
6 m
0 m
2 m
1 -
Top view
2 -
Side view
26 ft
39 ft
52 ft
52 ft
39 ft
o
85
26 ft
13 ft
0 ft
8 m 10 m 12 m
14 m 16 m
50 ft
26 ft
39 ft
52 ft
13 ft
7.9 ft
7.9 ft
0 ft
8 m 10 m 12 m
14 m 16 m
15.2 m
3/09 | F01U126810-01 | 3
1
2
Advertisement
