Extraordinary Maintenance; Troubleshooting; Assistance And Spare Parts - Ferroli FCS-C Series Installer Manual

EXTRAORDINARY MAINTENANCE

Extraordinary maintenance:
· The electric panel can be easily accessed by removing the cover. The condensation tray must be removed
in order to inspect or replace the internal components, such as: fan, heat exchange bank, condensation drain
pump and safety micro-float.
How to remove the condensation tray:
· Protect the floor underneath the unit from spilt condensation by means of a sheet of plastic when the
condensation tray is being removed.
· Remove the delivery and intake pipes together and drain the condensation from the tray into a bucket with a
capacity of at least 10 liters, through the relative pipe with rubber plug.
· Unscrew the fixing screws from the sides of the tray the then remove the condensation tray with care.

TROUBLESHOOTING

FAULT
Insufficient air outlet
Fails to produce heat
Fails to produce cold
The fan fails to turn

ASSISTANCE AND SPARE PARTS

Ask the Dealer where the appliance was purchased for your nearest After-Sales Service center or consult the
Yellow Pages under the "Conditioners" or "Gas Boilers" headings.
ROUTINE MAINTENANCE
PROBABLE CAUSE
-Wrong speed selected on the control panel.
-Filter clogged.
-Air flow obstructed (on the inlet and/or outlet).
-No hot water.
-Wrong setting on control panel.
-No cold water.
-Wrong setting on control panel.
-No power.
-In winter mode, the fan power supply depends
on activation of the enabling thermostat (if
installed). The ventilating action will only start
when the temperature of the water reaches 35°C.
REMEDY
-Select the speed on the control
panel.
-Check the boiler.
-Change setting on control
panel.
-Check the coolant.
-Change setting on control
panel.
-Check the boiler.
49