Advertisement
• The straw set is detachable for cleaning and sterilising. Sterilise
the straw set by using a Philips Avent steriliser or boiling for
5 minutes. This is to ensure hygiene. To prevent irreversible
deformation or damage to the product due to prolonged
exposure to the high-temperature bottom or wall of the steriliser,
the amount of water should be sufficient to submerge all the
components.
• Keeping the components in boiling water for too long may affect
their service life.
• Do not boil the insulated straw cup body, or sterilise it with a
steam or microwave steriliser.
• Do not put the insulated straw cup in a freezer compartment.
• Never fill over-heated water in the insulated straw cup as it may
cause scalding.
• Do not load large ice cubes. Break them into smaller pieces to
avoid leakage. Do not load dry ice.
• Do not over tighten the lid on the insulated straw cup.
• Do not use the insulated straw cup to mix and shake infant
formula as it may clog the vent hole and cause leakage.
• Make sure that the straw set are assembled properly.
• After drinking up the water in the insulated straw cup, shake the
insulated straw cup to pour out any remaining liquid.
• For hygiene reasons, replace the straw set at least every 3
months of use. Use only Philips Avent insulated cup straw set.
Introduction
Congratulations on your purchase and welcome to Philips Avent!
To fully benefit from the support that Philips offers, register your
product at www.philips.com/welcome.
Before first use
• Remove all packaging material from the product and keep it out
of the reach of children.
• Clean the insulated straw cup and parts thoroughly before the
first use. Refer to the chapter "Cleaning".
5-English
Advertisement
