Table of Contents
Advertisement
ENGINE OIL DIPSTICK - 1.0L
ECOBOOST
A
E141337
A
Minimum
B
Maximum
ENGINE OIL DIPSTICK - 1.5L
DURATEC-16V TI-VCT (81KW/
110PS) - SIGMA
A
B
E95540
A
Minimum
B
Maximum
ENGINE OIL CHECK
1.
Make sure that your vehicle is on level
ground.
2. Switch off the engine and wait 10
minutes for the oil to drain into the oil
pan.
3. Remove the dipstick and wipe it with
a clean, lint free cloth. Replace the
dipstick and remove it again to check
the oil level.
Fiesta (CC3) Vehicles Built From: 14-07-2014, Australia, enAUS
Maintenance
B
If the oil level is at the minimum mark, add
oil immediately.
Note: Check the oil level before starting the
engine.
Note: Make sure that the oil level is
between the minimum and the maximum
marks.
Note: Do not use oil additives or other
engine treatments. Under certain conditions,
they may damage the engine.
Note: The oil consumption of new engines
reaches its normal level after approximately
3000 miles (5000 kilometers).
Adding Oil
WARNINGS
Only add oil when the engine is cold.
If the engine is hot, wait 10 minutes
for the engine to cool down. Failure
to take care may result in personal injury.
Do not remove the filler cap when
the engine is running. Failure to take
care may result in personal injury.
1.
Remove the filler cap.
2. Add oil that meets Ford specifications.
3. Replace the filler cap. Turn it until you
feel a strong resistance.
Note: Do not add oil further than the
maximum mark. Oil levels above the
maximum mark may cause engine damage.
Note: Soak up any spillage with an
absorbent cloth immediately.
ENGINE COOLANT CHECK
WARNING
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse the
affected areas immediately with
plenty of water and contact your physician.
122
Advertisement
Table of Contents
Troubleshooting
