Troubleshooting - YZ Systems DynaPak DP-2020N Manual

11. Troubleshooting

timer mode #5
Proportional-to-time
A. Set the mode switch to position #5.
B. Set the data switches to 00.0 to enter the diagnostic
mode of operation.
C. Depress the enter switch to load the value into the
memory.
D. This mode of operation enables the operator to increase
the solenoid output rate to one actuation every two seconds.
NOTE: the LCD stroke indicator should increment each
time the solenoid actuates.
LED Indicator Chart (proportional-to-time only)
green red
on off
off on
NOTE: on means for approximately one half second.
To test the LED indicators, depress the test switch located
on the front of the controller.
Timer Setting
A. Z-200/6.1 - all time settings are xx.x minutes
B. Z-200/6.10 - all time settings are x.xx minutes.
YZ Systems, Inc. • 3101
DynaPak 2020N 09242003 ATEX Rev.
condition
solenoid on, good battery
solenoid on, low battery
Pollok Drive • Conroe, Texas • USA • 77303 • P: 936.788.5593 • F: 936.788.5720
19