Steering Wheel - Stiga VILLA SENATOR Manual

GB
GENERAL
This symbol indicates WARNING. Per-
sonal injury and/or damage to property
may result if the instructions are not fol-
lowed carefully.
SYMBOLS
The following symbols are displayed on the ma-
chine in order to remind you about the safety pre-
cautions and attention necessary when using the
machine.
The symbols mean:
Warning!
Read the instruction book and safety man-
ual before using the machine.
Warning!
Beware of objects being flung out. Keep
spectators away.
Warning!
Always use hearing protectors (earplugs
or muffs).
Warning!
This machine is not designed to be driven
on public roads.
ASSEMBLY
To avoid personal injury and damage to
property, never try to start the engine
before all the operations described un-
der ASSEMBLY have been completed.
ACCESSORIES BAG
A plastic bag is enclosed with the machine contain-
ing:
ENGLISH
Pos. Qty Name
AC 1
AD 1
AF 2
AG 2
AH 4
AI 2
AJ 2
AK 1
AL 1
AM 1
AN 1
AP 1
SEAT
Screw both seat adapters AF securely to the bottom
of the seat using screws AH. Do not forget to place
the coach bolts AI in the square centre holes first
(figs 1, 3).
Depending on the type of seat used, the adapter
should be turned so that the gap between coach bolts
is always 207 mm (figs 2, 4).
Screw the seat to the machine with the help of flat
washers AJ and locking knobs AG.
CONTROL KNOB (President)
Press home the control knob AN onto the drive le-
ver (fig 5).

STEERING WHEEL

Shims AL and/or AM should be inserted between
the upper and lower parts of the jacket tube to com-
pensate for any axial play (fig 6).
Before fitting the locating pin, check to see how
many washers are required.
The steering wheel must be fitted so that the knob
on the wheel is in the "10 o'clock" position (see
fig 5), (for Senator, President only).
Fit the steering wheel on the steering column using
locating pin AK (fig 6).
TOW BAR (Senator - President)
Attach the tow bar AP under the muffler. Use the
screw that already holds the muffler (fig 27).
ENGINE CASING
Loosen the screw which fastens the front part of the
engine casing to the chassis.
Then unhook the three rubber loops D and E (fig 7).
Dim.
Sparking plug sleeve
Torsion pin for ditto
Seat adapter
Locking knob
Screw 5/16" x 16
Coach bolt 8 x 20
Flat washer 8.4 x 22 x 1.5
Tensioner pin 6 x 36
Shim 16 x 38 x 0.5
Shim 16 x 38 x 1.0
Control knob (President)
Tow bar (Senator, President)