Sanyo MIR-153 Instruction Manual page 16

Downloaded from https://www.rsmanuals.com
• To replace it, slide it from the floor into the
unit, pushing it all the way in. Then, from be-
neath the unit, push the tray back farther by
hand.
• Replace the 2 screws and secure tightly.
Q Cleaning the cabinet interior
[MIR-153, MIR-253]
• Turn off the power switch.
• Remove the shelves.
• Remove the cap at the bottom of the cabinet.
• Pull out the end of the drain hose from under
the cabinet and place it in a bucket.
• Wipe the cabinet clean with a soft cloth soaked
in a neutral detergent solution. Wipe off the
detergent solution with a cloth dampened in
fresh water.
[MIR-553]
• Turn off the power switch.
• Remove the shelves.
• Remove the suction hole cover in the bottom of
the cabinet by pulling it from the top.
• There is a slope provided under the hole to
enable the water to drain. A drain plug is pro-
vided at the lower end. Remove it.
• Remove the 4 screws securing it, as illustrated.
The long hose extending from back to front as
viewed from the right side, is for draining, see
illustration below.
f - ^
©
• Wipe the cabinet interior clean with a soft cloth
soaked in a neutral detergent solution. Wipe off
the detergent solution with a cloth dampened
in fresh water.
• After cleaning, replace all the parts removed.
O Setting the shelves
The shelves can be adjusted to the height of
items placed inside. To adjust the height, insert
the self-support clips (4 per shelf) into the slots
at the desired height.
Q Replacing the glass protection plate
[MIR-153, MIR-2531
• Pull out the clip knobs mounted around the
plate. The knobs are reset by pulling out of 5
mm. Reset all clip knobs. Be sure that knobs
cannot be pulled out completely. (see figure)
Take off the protection plate. The plate may be
broken if the clip knobs are not reset competely.
Place a new plate so that the clips can be compli-
ance with the clip holes. Make sue the clips are
in reset position.
Insert the clips into the holes.
Push in the clip knobs.
-15-