Advertisement
Installation Instructions
Document No. 553-686
May 5, 2010
Installing the Migration Backplane
WARNING:
This installation should only be done by a
qualified electrician or an authorized
Siemens Industry, Inc. representative.
1. Unlock door, unfasten ground cable from door
and remove door from hinges.
2. Align extension with hinges on existing
enclosure, slide in place with lower extension lip
resting on lower enclosure flange.
3. Secure extension door to existing enclosure
using three spring clamps (provided), by pushing
clamps over right side flanges of extension and
enclosure at top, middle, and bottom.
4. Align door with extension hinges and slide in
place.
5. Secure ground cables from door and enclosure
to the stud on extension, using the two washers
and nut provided.
The installation is complete.
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and
models as design improvements are introduced. Other product or company names mentioned herein may be the trademarks of their
respective owners. © 2010 Siemens Industry, Inc.
Siemens Industry, Inc.
Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
U.S.A.
Your feedback is important to us. If you have
comments about this document, please send
them to
SBT_technical.editor@siemens.com
Figure 1. Door Extension.
Figure 2. Ground Cables.
Document No. 553-686
Printed in the USA
Page 2 of 2
Advertisement
