Darkly Labs Emblaser Core User & Assembly Manual page 11

STAGE 1 FRAME ASSEMBLY
Lay out the parts listed below. Refer to the 'PARTS Stage 1' section.
• Top Panel
• 2x Side Panel
• Front Panel
• Rear Panel
**Remove protective film from panels before starting construction**
• 8x Corner Bracket
• 6x Wall Bracket
• 4x Cable Management Clip
• 36x M3x12mm Screw
• 36x M3 Washer
• 24x M3 Nut
You will also need a 2.5mm Hex Tool. (This and other tools can be found in Box 1 (Accessories).
Step 1.01
Attach 4x Corner Brackets to the Rear Panel.
Important: Keep the feature indicated in green to the left.
M3 NUT
M3 WASHER
M3 x 12mm SCREW
11