Conference Call - Philips CT3308/00SRASIA User Manual

Mobile phone
Table of Contents

Advertisement

While in communication and one call being put on hold, you may receive a third
call. The phone emits an alert beep. You can either end one of the calls before
being able to answer the third one or introduce the calling party into a
conference (see below). This service is limited to two current communications
(one active and one on hold).
You can set up a conference call by making consecutive outgoing calls, or create
it from a multiparty call context. You may have up to five members at the same
time and end the conference with
In order to make consecutive outgoing calls, first initiate a normal call with the
first member of the conference. When the first member is on line, initiate a
second call as described in "Make a second call" above. When the second call
is engaged, press
five members are connected.
If there is an incoming call during the conference call, and if there is less than
five members, you can accept this new call by pressing
and then select
is an incoming call during a conference with five members already connected,
you can answer this new incoming call, but not add it to the conference.
While a conference call is in progress, press
options. Disconnect a member of the conference by selecting
and pressing
this member only (other members are put on hold).
You can connect an active call and a call on hold. You are disconnected
when the transfer is completed. During a call press
and press
L
72
If you have activated call forwarding 'If Busy' (see "Call forward" page 32),
you will never receive second calls since they are always forwarded when
the line is busy.
,
and select Conference. Repeat the above process until
Conference
,
to confirm, or select
,
.
This feature is different from the Call forward, which takes place before you pick
up the call (see page 32).
)
. At this point all calls are disconnected.
to add this member to the conference call. If there
,
Private call
,
,
. Press
to access the
Conf. members
Remove party
to have a private call with
,
, select
Other
operator
services
again
Transfer

Advertisement

Table of Contents
loading

Table of Contents