Pentair Pentek Intellidrive Quick Start Manual

What's in the box
Communication Hub Cord Grip
Power Adapter x2
1
Log in to www.mylink2o.com
to begin installation.
Create a new account
1a
-OR-
Login and Add to an existing Account
1b
After creating your account online, continue to step 2.
Changes or modifi cations not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
with
2
Remove cover from the drive
TM
2a
Shut off the power to the drive.
Gateway
[Wait 5 minutes to allow
capacitors to de-energize.]
2b
Cat5e Cable
Separate cover and back
plate.
Device ID Label
Connect Pentek ® communication hub to the drive
3
3a
Locate the P and N terminals in the I/O Connection area.
3b
Install the cord grip in the
bottom of the drive. Remove a
knock out if necessary. Pass the
cable through the cord grip.
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
Before beginning any installation, review Pentek Intellidrive
instructions and warnings. This guide neither supplements nor replaces the Owner's Manual.
4 Plug in and hook up the gateway
2c
4a
Verify there is a gap
between cover and 4b
back plate.
2d
5 Replace the drive cover and restore power to the drive
Pull out bottom of cover
5a
and remove.
Hook the cover onto the backplate,
lower it into place, and then push
3c
the cover back to close the gap.
5b
Connect the Red wire
to the P terminal and
the Black wire to the Plug the adapter into the
N terminal. Pentek communication hub.
correct the interference by one or more of the following measures: Reorient or relocate the
receiving antenna. Increase the separation between the equipment and receiver. Connect the
equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Quick Start Guide
Owner's Manual for complete
™
Hook up Cat5e cable between gateway and router.
Plug the adapter into
the gateway and a
standard outlet.
5c
Plug the adapter into a
standard outlet.
5d
When the LED on the
communication hub turns
solid green, installation is
complete.
© 2015 Pentair Ltd. All Rights Reserved. PN1014 (Rev. 09/18/15)