Emergency Contact; Entering Patient Information Into The Programmer; Entering Physician Emergency Contact Information; Programming Information - Neuropace RNS System User Manual

Programming Instructions
P I
ATIENT NFORMATION AND

Entering Patient Information into the Programmer

1. Go to the P
2. The user should enter the following information for each patient:
P
• ATIENT
G
• ENDER
D
• ATE OF

Entering Physician Emergency Contact Information

Physician emergency contact information may be entered for storage on the neurostimulator. This
information may be used by emergency medical personnel or another physician to contact the
patient's physician or caregiver.
1. Go to P
ATIENT
2. Enter information to be stored in RNS

Programming Information

Programming the RNS
the neurostimulator.
1. Select the P
2. Select R
EVIEW
3. Select the P
Note: ECoG storage triggers are inactive during programming. Programming clears activity
information and ECoGs stored in the neurostimulator. If there is any new information,
be sure to interrogate the neurostimulator prior to programming.
A L L
SSIGNING EAD ABELS AND
®
The RNS Neurostimulator can sense brain activity (ECoGs) from up to four amplifier channels.
Assigning lead labels and creating a montage is done using the programmer. If the montage is
altered, the detection settings that were created with the previous montage are no longer
available for use. The detection settings will need to be reprogrammed.

Assigning the Lead Labels

1. Go to the P
2. If not already entered, enter the appropriate lead type and serial number for
N
EUROSTIMULATOR
®
RNS System User Manual
P E
HYSICIAN MERGENCY
/P tab.
ATIENT RODUCT
I
DENTIFIER
and
B .
IRTH
/P tab.
RODUCT
®
Neurostimulator sends all newly entered information from the programmer to
S tab.
ROGRAM ETTINGS
C to view changes prior to programming.
HANGES
button.
ROGRAM
C M
REATING THE ONTAGE
/P tab.
ATIENT RODUCT
P #1 and N
ORT EUROSTIMULATOR
C I
ONTACT NFORMATION
®
Neurostimulator.
P #2.
ORT
59