How To Change Project Id With Rcu; How To Upgrade Ci Key Using Usb; How To Upgrade Netflex Esn Using Usb - TCL U65S9906 Service Manual

on above 1.2 section
 Send OAD manufacturing IR code [08d/60d] (refer to SIACP document rev. v5.9 for further information) or go
to "Factory menuOtherOAD update" and then press RCU "OK/►" key
 OAD will start automatically and several pop-up messages such as scanning/searching, downloading and
flashing will be skipped (acknowledged by default)
Once upgrading completed, TV may restart automatically after warm start and implicit ResetAll (in case of
NVM mapping/signature change) in previous Factory and/or Burn-in mode
Appendix (5) "How to change Project ID with RCU"

Process following subsequence IR codes to change projectID: 062598+MENU+xxx (xxx:ProjectID, ex: 001)

If it works, the TV will restart automatically.
Appendix ⑹ "How to upgrade CI Key using USB"
 Create a new folder named "CIKEY" on USB stick (pen driver) root path.
Copy corresponding "*.key" files into CIKEY folder.

 Under CIKEY folder, create a new folder named "backup" (once the CI key is overwritten, the matching key file
will be moved to this folder)

Plug USB stick to the TV
 Go to "Fa ctory menuOtherCIKey upgradeUpdate CI+ CredentialUpdate From USB" and then
press RCU "OK/►" key
The "Valid" flag should now be enabled (turns to "Yes"), "Custom Code" should display "TCL" and "Serial Num."
field should update with Key number.

Remove USB stick
If unfortunately the process failed, you may need to download new CI key and repeat operation again.
Note⑹:
Appendix ⑺ "How to upgrade Netflex ESN using USB"
 Under USB root path, create a new folder named as "
folder;
 Under "esn" path, the key should be named as "

Plug USB stick to the TV;
 Go to "Factory menuUSB Clone && Update ESN Key Upgrade" and then press RCU "OK" key
Test and Alignment Specification for MT58 Series (v0 01)
", then copy corresponding ESN KEY bin files into this
esn
",like this
nflxk_***
Page 17 of 26
160523
,