How To Upgrade Main Software Using Usb; How To Upgrade Main Sw Using Usb And Rcu; How To Upgrade Flash Sw By Oad - TCL U65S9906 Service Manual

Appendix ⑵ "How to upgrade main software using USB"
 Copy the MAIN SW BIN image "V8-T658T01.pkg" into USB stick (pen drive) root path.
 Please delete other xxx.pkg files from USB stick.
 Plug USB stick to the TV.
 Power on TV by AC, at the same time press "power on" key for 10s, TV will update SW automatically.
 When reflashing is successful, TV should restart automatically (about 4min).
 Remember to perform "Factory menuReset ALL" and "Factory menuReset Shop", and then press RCU
"OK/►" key.
 Finally, restart the TV.

Upgrade with
Appendix (3) How to upgrade main SW using USB and RCU（not support current
software）
 Power on TV.
 Copy the SW BIN image "V8-T658T01.pkg" into USB stick (pen drive) root path.
 Plug USB stick to the TV.
 Option-->settings--> Support--> Software update -->By USB. TV will find Vxxx and please do "update".
 TV will update SW automatically, and show some notes on TV.
 When reflashing is successful, TV should restart automatically after ~5min.
 Remember to perform "Factory menuReset ALL" and "Factory menuReset Shop" and then press RCU
"OK/►" key.
 Switch off TV by removing AC cord.
 Reconnect AC cord to restart TV.
If "Reset Shop" was performed, a "Welcome Setup" menu should be displayed, otherwise new SW version
Note⑩:
should be displayed into relevant Factory mode caption info or on bottom of "Factory menu"

Upgrade with
"
6M60.bin
Note⑾:
Appendix (4) "How to upgrade FLASH SW by OAD"
 Power on the TV.
 Set TV to Factory mode (enable Factory key) and/or Burn-in mode if necessary
 Connect RF antenna or whatever air antenna with suitable amplifier from any digital broadcasting system (ex:
DTA-115 Multi-Standard VHF/UHF Modulator - http://www.dektec.com/products/PCI/DTA-115/)
 Play DVB MPEG SSU TS, that includes suitable PKG SW image, with right presets (850MHz/8MHz/...) detailed
6M60.bin(Not support current software)
6M60.bin(Not support current software)
"
only applies to the TV which has the function of MEMC used Mstar IC MST6M60FV
Test and Alignment Specification for MT58 Series (v0 01)
Page 16 of 26
160523