Frico Elektra F Series Mounting And Assembly Instruction page 13

This should not be seen as a fault, but is simply
rectified by connecting the appliance to the
mains supply via a socket without a safety cut-
out, so that the moisture can be driven out of the
element.
The drying time can vary from a few hours to
a few days. As a preventive measure the heater
should occasionally be run for a short time when
it is not being used for an extended period of time.
Maintenance
Note! Opening the heater cover should only be
done by a qualified installer.
Always disconnect the power supply before
opening the cover or doing any maintenance
work.
The appliance should be cleaned reguarly both
inside and outside, to prevent overheating and
risk of fire but also to guarantee long life of the
heater.
Note! To keep the protection class it is very
important to tighten the screws properly when
the lid is put back again after installation or
maintenance. When the screw has reached the
rubber gasket, continue another 2 1/2 turns.
Safety instructions
Incorrect installation and/or incorrect usage of the
fan heater can be hazardous.
This appliance is not intended for use by persons
(including children) with reduced physical, senso-
ry or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
Type Description
ELS
Control panel , start/stop
Elektra F
Warning!
• Always disconnect the fan heater berfore
opening the cover or doing any electrical
work.
• Incorrect installation can lead to personal
injury.
• Opening the heater cover etc should only be
done by a qualified installer
• This fan heater must not be used next to a
shower, bath or swimming pool.
• Place the fan heater away from flammable
materials
• Ensure that the area around the intake and
exhaust grille is kept free from material
which could obstruct the air flow through
the unit!
• During operation the surfaces of the unit
are hot!
• The unit must not be covered fully or
partially with clothes, or similar materials,
as overheating can result in a fire risk!
• The fan heater is fitted with a cable that, in
the event of damage, must be changed by a
qualified installer.
Important!
When using the heater as a portable, the brackets
must be turned in order to use them as a floor
stand (see fig 4 on page 3).
The guarantee is only valid if the units are used
in the manner intended by the manufacturer
and in accordance with the installation and
maintenance instructions.
Accessories
For fixed installation the heater can be controlled
by an external control panel for start/stop. Please
note minimum distance 1800 mm, see fig. 2 page
3. ELS can only control one unit.
See table below.
Dimensions
HxWxD
[mm]
105x70x80
GB
13