Table of Contents
Advertisement
A A EE Unmanned Aircraft System
Professional Leading
Parameter setting of the power battery charger of the aircraft
[Parameter setting and charging]
Set the charger parameters as follows after the battery and charger are connected:
Click the "PAUSE" button and change the battery type to "LIPO" under "BATTERY TYPE". (When the
1.
battery type keeps flashing, "UP" and "DOWN" buttons can be used to select the battery type);
After selecting the battery mode, click the "PAUSE" button again and set the battery cell number to
2.
"6S" under "CELLS". (When the cell number keeps flashing, "UP" and "DOWN" buttons can be used
to select the cell number);
3.
After selecting the cell, click the "PAUSE" button again and adjust the charging mode to
"BALANCE CHARGE" under "MODE".
(When the charging mode keeps flashing, "UP" and "DOWN" buttons can be used to select the
charging mode);
4. After selecting the charging mode, click the "PAUSE" button again and adjust the charging current
parameter to "7.0A" under "CURRENT". (When the current keeps flashing, "UP" and "DOWN" buttons
can be used to select the current);
5. After all parameters are set, long press the "PAUSE" button for a prompt sound, which means
thatcharging is successful.
6. When the battery is fully charged, click the "PAUSE" button to stop charging.
【Precautions for use of lithium battery】
1.
Do not remove or reassemble the battery
2.
Do not short circuit the battery or connect it in reverse electrode
3.
Do not use near heat sources
4.
Do not put the battery into water or wet it
5.
Do not charge near fire or under direct sunlight
6.
Do not crush or throw it
7.
Do not use the battery under the condition of serious damage or deformation
8.
No reverse charging or over discharging (otherwise, it may cause battery bulging, leakage, cell breakdown, even
explosion, etc.)
9.
Waste batteries should be recycled for environmental protection
10.
If the battery will be left unused for a long time, it is recommended to take out the battery and place it
separately and charge it every 3 months. The batteries should be charged to 27.5V for storage, so as to maintain
the battery performance and extend its service life. Press the voltage difference detection button first when
using the battery. If the value is larger than 0.1V, the battery cannot be used, and needs to be maintained and
detected again.
Aircraft
The AEE unmanned aircraft system integrates flight control software, digital radio, HD image transmission,
control joystick, and task control buttons to facilitate easy viewing of flight data and real-time images during
flight, and the remote control physical button, switch, joystick or GS software enable the drone to perform
various real-time route monitoring and mission control such as fixed-point hovering, route flight, and automatic
return.
It is strictly forbidden to remove the
charging cable from the charger before
turning off the power switch in order to
avoid short circuit caused by accidental
contact between the positive and negative
charging connectors, resulting in battery
damage or other safety accidents.
Advertisement
Table of Contents
