•
Use a 5.5 mm round file with a file holder.
•
Hold the file at an angle of 15°.
•
Sharpen one tooth of the saw blade to the right and
the next tooth to the left, see the illustration.
Note: Sharpen the edges of the teeth with a flat file if
the blade is heavily worn. Continue to sharpen with a
round file.
•
Sharpen all edges equally to keep the blade
balanced.
•
Adjust the blade set to 1 mm with the recommended
setting tool. Refer to the instructions that come with
the blade.
WARNING: Always discard a blade that is
damaged. Do not try to make a bent or
twisted blade straight and use it again.
To examine the spark plug
CAUTION: Always use the recommended
spark plug type. Incorrect spark plug type
can cause damage to the product.
•
Examine the spark plug if the engine is low on
power, is not easy to start or does not operate
correctly at idle speed.
28
15˚
•
To decrease the risk of unwanted material on the
spark plug electrodes, obey these instructions:
a) Make sure that the idle speed is correctly
adjusted.
b) Make sure that the fuel mixture is correct.
c) Make sure that the air filter is clean.
•
If the spark plug is dirty, clean it and make sure that
the electrode gap is correct, refer to
on page 31 .
•
Replace the spark plug if it is necessary.
To adjust the product for cold
environments
CAUTION: Snow and cold weather can
cause operation problems. There is a risk of
too low engine temperature or ice on the air
filter and the carburetor.
There is a winter kit available for your product. The
winter kit includes the components that follow:
A
B
•
An air filter cover without air intake (A).
•
A cover for the air filter holder (B).
•
A cover for the starter housing (C).
•
A wear guard with an air duct (D).
•
An air filter (E).
•
In temperatures below 0°C/32°F, do the steps that
follow.
Technical data
C
D
E
1346 - 002 - 08.10.2019