Powering On And Recording - Tactacam 4.0 Quick Start Manual

GETTING TO KNOW YOUR TACTACAM:

POWERING ON AND RECORDING

1. Push the Rec/Power button. You will
feel the camera vibrate 2 times and see a
blinking green light coming from the rec/
power button. The green LED must be
blinking for the camera to be recording.
Note: Tactacam 2.0 will vibrate 1 long
and 2 short times when powered On. The
process takes approximately 3 seconds.
(Note: if light does not begin to flash make
sure your sd card is installed, formatted
and not filled with videos)
2. To pause your recording quickly push
the Rec/Power button. The camera will
vibrate 1 time and the green light will stop
blinking.
3. To power your camera completely off
just push and hold the Rec/Power button
for 4 sec.
4. The camera automatically will power
off to save battery when not recording (left
in pause mode) after 3 min (Tactacam 2.0
powers off after 5 min)
7 TACTACAM.COM